HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 227

Port Status and Configuration Viewing Port Status and Configuring Port Parameters ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi Status and Counters - Custom Port Status Intrusion Port Name Type VLAN Alert Speed Enabled MDI-mode 1 Acco 100/1000T 1 No 1000FDx Yes Auto 2 Huma 100/1000T 1 No 1000FDx Yes Auto 3 Deve 100/1000T 1 No 1000FDx Yes Auto 4 Lab1 100/1000T 1 No 1000FDx Yes Auto Figure 10-6. Example of the Custom show interfaces Command You can specify the column width by entering a colon after the column name, then indicating the number of characters to display. In Figure 10-6 the Name column only displays the first four characters of the name. All remaining characters are truncated. Note Each field has an fixed minimum width to be displayed. If you specify a field width smaller than the minimum width, the information is displayed at the minimum width. For example, if the minimum width for the Name field is 4 characters and you specify Name:2, the Name field displays 4 characters. Parameters can be entered in any order. There is a limit of 80 characters per line; if you exceed this limit an error displays. Error Messages Error Error Message Requesting too many fields (total characters Total length of selected data exceeds one line exceeds 80) Field name is misspelled Invalid input: Mistake in specifying the port list Module not present for port or invalid port: The port list is not specified Incomplete input: custom 10-12