HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 230
Enabling or Disabling Ports and Configuring Port Mode, non-operational, enable
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
Port Status and Configuration Viewing Port Status and Configuring Port Parameters Operating Notes: ■ The following information is displayed for each installed transceiver: • Port number on which transceiver is installed. • Type of transceiver. • Product number-Includes revision letter, such as A, B, or C. If no revision letter follows a product number, this means that no revision is available for the transceiver. • Part number-Allows you to determine the manufacturer for a specified transceiver and revision number. ■ For a non-ProCurve installed transceiver (see line 23 Figure 10-8), no transceiver type, product number, or part information is displayed. In the Serial Number field, non-operational is displayed instead of a serial number. ■ The following error messages may be displayed for a non-operational transceiver: • Unsupported Transceiver. (SelfTest Err#060) Check: www.hp.com/rnd/device_help/2_inform for more info. • This switch only supports revision B and above transceivers. Check: www.hp.com/rnd/device_help/ 2_inform for more info. • Self test failure. • Transceiver type not supported in this port. • Transceiver type not supported in this software version. • Not a ProCurve Transceiver. Please go to: www.hp.com/rnd/device_help/2_inform for more info. Enabling or Disabling Ports and Configuring Port Mode You can configure one or more of the following port parameters. Refer to table 10-1 on pages 10-4 through 10-5. Syntax: [no] interface < port-list > [< disable | enable >] Disables or enables the port for network traffic. Does not use the no form of the command. (Default: enable.) speed-duplex < auto-10 |10-full | 10-half | 100-full | 100-half |auto| auto100 | 1000-full >] 10-15