HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 178
Con Multiple IP Addresses on a VLAN Multinetting., DHCP/Bootp, Disabled
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Configuring IP Addressing IP Configuration Note The default IP address setting for the DEFAULT_VLAN is DHCP/Bootp. On additional VLANs you create, the default IP address setting is Disabled. Syntax: [ no ] vlan < vlan-id > ip address or [ no ] vlan < vlan-id > ip address < ip-address > < mask-bits > or vlan < vlan-id > ip address dhcp-bootp This example configures IP addressing on the default VLAN with the subnet mask specified in mask bits. ProCurve(config)# vlan 1 ip address 10.28.227.103 255.255.255.0 This example configures the same IP addressing as the preceding example, but specifies the subnet mask by mask length. ProCurve(config)# vlan 1 ip address 10.28.227.103/24 This example deletes an IP address configured in VLAN 1. ProCurve (config) no vlan 1 ip address 10.28.227.103/24 Configure Multiple IP Addresses on a VLAN (Multinetting). The following is supported: ■ Up to 2000 IP addresses for the switch ■ Up to 32 IP addresses for the same VLAN ■ Up to 512 IP VLANs, that is, VLANs on which you can configure IP addresses ■ Each IP address on a VLAN must be for a separate subnet, whether on the same VLAN or different VLANs. Syntax: [ no ] vlan < vlan-id > ip address < ip-address/mask-length > [ no ] vlan < vlan-id > ip address < ip-address > < mask-bits > For example, if you wanted to multinet VLAN_20 (VID = 20) with the IP addresses shown below, you would perform steps similar to the following. (For this example, assume that the first IP address is already configured.) IP Address VID 1st address 20 2nd address 20 3rd address 20 IP Address 10.25.33.101 10.26.33.101 10.27.33.101 Subnet Mask 255.255.240.0 255.255.240.0 255.255.240.0 8-8