HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 406
Copying Crash Data Content to a Destination Device, A-12.
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 406 highlights
File Transfers Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation At this point, press [Enter] and start the Xmodem command sequence in your terminal emulator. Figure A-12. Example of Sending Event Log Content to a File on an Attached PC Copying Crash Data Content to a Destination Device This command uses TFTP, USB, or Xmodem to copy the Crash Data content to a destination device. You can copy individual slot information or the management module's switch information. If you do not specify either, the command defaults to the management function's data. Syntax: copy crash-data [master>] tftp copy crash-data [mm>] usb copy crash-data [mm>] xmodem where: mm Retrieves crash log or crash data from the switch's chassis processor. When "mm" is specified, crash files from both management modules are copied. These commands copy the crash data content to a remote host, attached USB device, or to a serially connected PC or UNIX workstation. You can copy the management module (mm) switch information. If you do not specify either, the command defaults to the mm data. For example, to copy the switch's crash data to a file in a PC: At this point, press [Enter] and start the Xmodem command sequence in your terminal emulator. Figure A-13. Example of Copying Switch Crash Data Content to a PC A-32