HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 511
Port Auto-Negotiation, Ping and Link Tests, Ping Test.
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 511 highlights
Note Troubleshooting Diagnostic Tools Port Auto-Negotiation When a link LED does not light (indicating loss of link between two devices), the most common reason is a failure of port auto-negotiation between the connecting ports. If a link LED fails to light when you connect the switch to a port on another device, do the following: 1. Ensure that the switch port and the port on the attached end-node are both set to Auto mode. 2. If the attached end-node does not have an Auto mode setting, then you must manually configure the switch port to the same setting as the endnode port. Refer to Chapter 10, "Port Status and Configuration". Ping and Link Tests The Ping test and the Link test are point-to-point tests between your switch and another IEEE 802.3-compliant device on your network. These tests can tell you whether the switch is communicating properly with another device. To respond to a Ping test or a Link test, the device you are trying to reach must be IEEE 802.3-compliant. Ping Test. This is a test of the path between the switch and another device on the same or another IP network that can respond to IP packets (ICMP Echo Requests). To use the ping (or traceroute) command with host names or fully qualified domain names, refer to "DNS Resolver" on page C-79. Link Test. This is a test of the connection between the switch and a designated network device on the same LAN (or VLAN, if configured). During the link test, IEEE 802.2 test packets are sent to the designated network device in the same VLAN or broadcast domain. The remote device must be able to respond with an 802.2 Test Response Packet. C-57