HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 205
TimeP: Viewing, Selecting, and Configuring
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Time Protocols TimeP: Viewing, Selecting, and Configuring TimeP: Viewing, Selecting, and Configuring TimeP Feature view the Timep time synchronization configuration select Timep as the time synchronization method disable time synchronization enable the Timep mode DHCP manual none/disabled change the SNTP poll interval Default n/a TIMEP timep Disabled - - - 720 minutes Menu page 9-17 page 9-15 page 9-17 page 9-17 page 9-17 page 9-17 page 9-18 CLI Web page 9-19 - pages 9-21 ff. - page 9-23 - - page 9-21 - page 9-22 - page 9-24 - page 9-23 - Table 9-2. Timep Parameters SNTP Parameter Operation Time Sync Method Used to select either TIMEP (the default), SNTP, or None as the time synchronization method. Timep Mode Disabled The Default. Timep does not operate, even if specified by the Menu interface Time Sync Method parameter or the CLI timesync command. DHCP When Timep is selected as the time synchronization method, the switch attempts to acquire a Timep server IP address via DHCP. If the switch receives a server address, it polls the server for updates according to the Timep poll interval. If the switch does not receive a Timep server IP address, it cannot perform time synchronization updates. Manual When Timep is selected as the time synchronization method, the switch attempts to poll the specified server for updates according to the Timep poll interval. If the switch fails to receive updates from the server, time synchronization updates do not occur. Server Address Used only when the TimeP Mode is set to Manual. Specifies the IP address of the TimeP server that the switch accesses for time synchronization updates. You can configure one server. 9-16