HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 137
Listing and Displaying Startup-Config Files, Viewing the Startup-Config File Status with Multiple
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Switch Memory and Configuration Multiple Configuration Files Listing and Displaying Startup-Config Files Command show config files show config < filename > Page Below 6-30 Viewing the Startup-Config File Status with Multiple Configuration Enabled Rebooting the switch automatically enables the multiple configuration feature. Syntax: show config files This command displays the available startup-config files on the switch and the current use of each file. id: Identifies the memory slot for each startup-config file available on the switch. act: An asterisk ( * ) in this column indicates that the corresponding startup-config file is currently in use. pri: An asterisk ( * ) in this column indicates that the corresponding startup-config file is currently assigned to the primary boot path. sec: An asterisk ( * ) in this column indicates that the corresponding startup-config file is currently assigned to the secondary boot path. name: Shows the filename for each listed startup-config file in the switch. Refer to "Renaming an Existing Startup-Config File" on page 6-33 for the command you can use to change existing startup-config filenames. In the default configuration, if the switch was shipped from the factory with software installed in both the primary and secondary boot paths, then one startup-config file named config1 is used for both paths and is stored in memory slot 1. Memory slots 2 and 3 are empty in this default configuration. 6-29