HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 201
Syntax, ProCurveconfig# timesync sntp
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
Time Protocols SNTP: Viewing, Selecting, and Configuring second or third server, you must use the CLI. For more on SNTP operation with multiple servers, refer to "SNTP Unicast Time Polling with Multiple SNTP Servers" on page 9-25. Syntax: timesync sntp Selects SNTP as the time synchronization method. Syntax: sntp unicast Configures the SNTP mode for Unicast operation. Syntax: sntp server [version] Specifies the SNTP server. Server version values are between 1 and 7. The default server version is 3. Syntax: sntp server priority Specifies the order in which the configured SNTP servers are polled for getting the time. Value is between 1 and 3. Note Syntax: [no] sntp server priority [oobm] [version] Use the no version of the command to disable SNTP. priority specifies the order in which the configured SNTP servers are polled for the time; allowable values are 1 through 3. ip-address is an IPv4 or IPv6 address of an SNTP server. For switches that have a separate out-of-band management port, oobm specifies that SNTP traffic goes through that port. (By default, SNTP traffic goes through the data ports.) version is the protocol version of the SNTP server. Allowable values are 1 through 7; default is 3. Syntax: no sntp server < ip-addr > Deletes the specified SNTP server. Deleting an SNTP server when only one is configured disables SNTP unicast operation. For example, to select SNTP and configure it with unicast mode and an SNTP server at 10.28.227.141 with the default server version (3) and default poll interval (720 seconds): ProCurve(config)# timesync sntp Selects SNTP. 9-12