HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 209

Time Protocols TimeP: Viewing, Selecting, and Configuring Syntax: show management This command can help you to easily examine and compare the IP addressing on the switch. It lists the IP addresses for all time servers configured on the switch, plus the IP addresses and default gateway for all VLANs configured on the switch. ProCurve(config)# show management Status and Counters - Management Address Information Time Server Address : 10.10.28.100 Priority SNTP Server Address Protocol Version 1 10.10..28.101 3 2 10.255.5.24 3 3 fe80::123%vlan10 3 Default Gateway : 10.0.9.80 VLAN Name MAC Address | IP Address DEFAULT_VLAN 001279-88a100 | 10.30.248.184 VLAN10 001279-88a100 | 10.0.10.17 Figure 9-15. Example of Display Showing IP Addressing for All Configured Time Servers and VLANs Configuring (Enabling or Disabling) the TimeP Mode Enabling the TimeP mode means to configure it for either broadcast or unicast mode. Remember that to run TimeP as the switch's time synchronization protocol, you must also select TimeP as the time synchronization method by using the CLI timesync command (or the Menu interface Time Sync Method parameter). Syntax: timesync timep Selects TimeP as the time protocol. Syntax: ip timep < dhcp | manual > Enables the selected TimeP mode. Syntax: no ip timep Disables the TimeP mode. Syntax: no timesync Disables the time protocol. 9-20