HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 215

Time Protocols SNTP Messages in the Event Log Adding and Deleting SNTP Server Addresses Adding Addresses. As mentioned earlier, you can configure one SNTP server address using either the Menu interface or the CLI. To configure a second and third address, you must use the CLI. To configure the remaining two addresses, you would do the following: ProCurve(config)# sntp server 2001:db8::215:60ff:fe79:8980 ProCurve(config)# sntp server 10.255.5.24 Figure 9-21. Example of Creating Additional SNTP Server Addresses with the CLI Note If there are already three SNTP server addresses configured on the switch, and you want to use the CLI to replace one of the existing addresses with a new one, you must delete the unwanted address before you configure the new one. Deleting Addresses. To delete an address, you must use the CLI. If there are multiple addresses and you delete one of them, the switch re-orders the address priority. Syntax: no sntp server < ip-addr > For example, to delete the primary address in the above example (and automatically convert the secondary address to primary): ProCurve(config)# no sntp server 10.28.227.141 Menu: Operation with Multiple SNTP Server Addresses Configured When you use the Menu interface to configure an SNTP server IP address, the new address writes over the current primary address, if one is configured. SNTP Messages in the Event Log If an SNTP time change of more than three seconds occurs, the switch's event log records the change. SNTP time changes of less than three seconds do not appear in the Event Log. 9-26