HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 382
A-4., Example of the Command to Download an OS Switch Software, When the download finishes
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 382 highlights
File Transfers Downloading Switch Software This command automatically downloads a switch software file to primary or secondary flash. Note that if you do not specify the flash destination, the TFTP download defaults to primary flash. For switches that have a separate out-of-band management port, the oobm parameter specifies that the traffic will go through the out-of-band management interface. If this parameter is not specified, the traffic goes through the data interface. For example, to download a switch software file named k0800.swi from a TFTP server with the IP address of 10.28.227.103 to primary flash: 1. Execute copy as shown below: z Dynamic counter continually displays the number of bytes transferred. This message means that the image you want to upload will replace the image currently in primary flash. Figure A-4. Example of the Command to Download an OS (Switch Software) 2. When the switch finishes downloading the software file from the server, it displays this progress message: Validating and Writing System Software to FLASH ... 3. When the download finishes, you must reboot the switch to implement the newly downloaded software image. To do so, use one of the following commands: Syntax: boot system flash < primary | secondary > Boots from the selected flash. Syntax: reload Boots from the flash image and startup-config file. A switch covered in this guide (with multiple configuration files), also uses the current startup-config file. (For more on these commands, refer to "Rebooting the Switch" on page 6-19.) A-8