HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 311
General Steps for Configuring SNMP Notifications
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 311 highlights
Configuring for Network Management Applications Using SNMP Tools To Manage the Switch ■ Advance Traffic Management Guide: • Loop protection • Spanning Tree (STP, RSTP, MSTP) ■ Access Security Guide: • MAC lockdown • MAC lockout • Uni-Directional Link Detection (UDLD) General Steps for Configuring SNMP Notifications To configure SNMP notifications, follow these general steps: 1. Determine the versions of SNMP notifications that you want to use in your network. If you want to use SNMPv1 and SNMPv2c traps, you must also configure a trap receiver. Refer to the following sections and follow the required configuration procedures: • "SNMPv1 and SNMPv2c Traps" on page 13-20 • "Configuring an SNMP Trap Receiver" on page 13-20 • "Enabling SNMPv2c Informs" on page 13-22 If you want to use SNMPv3 notifications (including traps), you must also configure an SNMPv3 management station. Follow the required configuration procedure in the following section: • "Configuring SNMPv3 Notifications" on page 13-24 2. To reconfigure any of the SNMP notifications that are enabled by default to be sent to a management station (trap receiver), refer to the following section: • "Enabling Link-Change Traps" on page 13-29 3. (Optional) Refer to the following sections to configure optional SNMP notification features and verify the current configuration: • "Configuring the Source IP Address for SNMP Notifications" on page 13-30 • "Displaying SNMP Notification Configuration" on page 13-32 13-19