HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 218
Overview, Viewing Port Status and Configuring Port Parameters, Note On Connecting, Transceivers
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
Port Status and Configuration Overview Overview This chapter describes how to view the current port configuration and how to configure ports to non-default settings, including ■ Enable/Disable ■ Mode (speed and duplex) ■ Flow Control ■ Broadcast Limit ■ Friendly Port Names ■ Uni-directional Link Detection (UDLD) Viewing Port Status and Configuring Port Parameters Port Status and Configuration Features Feature Default viewing port status n/a viewing transceiver status n/a configuring ports Refer to Table 10-1 on pages 10-4 thru 10-5 configuring ProCurve auto-mdix Menu page 10-6 n/a page 10-7 CLI page 10-8 page 10-14 page 10-15 Web page 10-22 page 10-22 page 10-22 page 9-11 Note On Connecting Transceivers to Fixed-Configuration Devices If the switch either fails to show a link between an installed transceiver and another device, or demonstrates errors or other unexpected behavior on the link, check the port configuration on both devices for a speed and/or duplex (mode) mismatch. ■ To check the mode setting for a port on the switch, use either the Port Status screen in the menu interface (page 10-6) or show interfaces brief in the CLI (page 10-8). To display information about the transceivers installed on a switch, enter the show tech receivers command in the CLI (page 10-14). 10-3