HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 208
Viewing the Current TimeP Configuration
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Time Protocols TimeP: Viewing, Selecting, and Configuring Viewing the Current TimeP Configuration Using different show commands, you can display either the full TimeP configuration or a combined listing of all TimeP, SNTP, and VLAN IP addresses configured on the switch. Syntax: show timep This command lists both the time synchronization method (TimeP, SNTP, or None) and the TimeP configuration, even if SNTP is not the selected time protocol. (If the TimeP Mode is set to Disabled or DHCP, then the Server field does not appear.) For example, if you configure the switch with TimeP as the time synchronization method, then enable TimeP in DHCP mode with the default poll interval, show timep lists the following: ProCurve (config)# show timep Timep Configuration Time Sync Mode: Timep TimeP Mode [Disabled] : Manual Server Address : 10.10.28.100 Poll Interval (min) [720] : 720 OOBM : Yes Figure 9-13. Example of TimeP Configuration When TimeP Is the Selected Time Synchronization Method If SNTP is the selected time synchronization method, show timep still lists the TimeP configuration even though it is not currently in use: ProCurve (config)# show timep Timep Configuration Time Sync Mode: Sntp TimeP Mode [Disabled] : Manual Server Address : 10.10.28.100 Poll Interval (min) [720] : 720 OOBM : Yes Even though, in this example, SNTP is the current time synchronization method, the switch maintains the TimeP configuration. Figure 9-14. Example of TimeP Configuration When TimeP Is Not the Selected Time Synchronization Method 9-19