HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 169

Interface Access and System Information System Information Syntax: mac-age-time < 10 - 1000000 > (seconds) Allows you to set the MAC address table's age-out interval. An address is aged out if the switch does not receive traffic from that MAC address for the age-out interval, measured in seconds. Default: 300 seconds. For example, to configure the age time to seven minutes: ProCurve(config)# mac-age-time 420 Configure the Time Zone and Daylight Time Rule. These commands: ■ Set the time zone you want to use ■ Define the daylight time rule for keeping the correct time when daylight- saving-time shifts occur. Syntax: time timezone < -720 - 840 > time daylight-time-rule < none | alaska | continental-us-and-canada | middle-europe-and-portugal | southern-hemisphere | western-europe | user-defined> East of the 0 meridian, the sign is "+". West of the 0 meridian, the sign is "-". For example, the time zone setting for Berlin, Germany is +60 (zone +1, or 60 minutes), and the time zone setting for Vancouver, Canada is -480 (zone -8, or -480 minutes). To configure the time zone and daylight time rule for Vancouver, Canada: ProCurve(config)# time timezone -480 daylight-time-rule continental-us-and-canada Configure the Time and Date. The switch uses the time command to configure both the time of day and the date. Also, executing time without parameters lists the switch's time of day and date. Note that the CLI uses a 24-hour clock scheme; that is, hour (hh) values from 1 p.m. to midnight are input as 13 - 24, respectively. Syntax: time [ hh:mm [ :ss ]] [ mm/dd/ [ yy ] yy ] For example, to set the switch to 9:45 a.m. on November 17, 2002: ProCurve(config)# time 9:45 11/17/02 Note Executing reload or boot resets the time and date to their default startup values. 7-18