HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 267
Configuring a Static Trunk or Static LACP Trunk Group., Removing Ports from a Static Trunk Group.,
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
Caution Port Trunking CLI: Viewing and Configuring Port Trunk Groups Configuring a Static Trunk or Static LACP Trunk Group. Syntax: trunk < port-list > < trk1 ... trk60 > < trunk | lacp > Configures the specified static trunk type. This example uses ports C4 - C6 to create a non-protocol static trunk group with the group name of Trk2. ProCurve(config)# trunk c4-c6 trk2 trunk Removing Ports from a Static Trunk Group. This command removes one or more ports from an existing Trkx trunk group. Removing a port from a trunk can create a loop and cause a broadcast storm. When you remove a port from a trunk where spanning tree is not in use, ProCurve recommends that you first disable the port or disconnect the link on that port. Syntax: no trunk < port-list > Removes the specified ports from an existing trunk group. For example, to remove ports C4 and C5 from an existing trunk group. ProCurve(config)# no trunk c4-c5 Enabling a Dynamic LACP Trunk Group. In the default port configuration, all ports on the switch are set to disabled. To enable the switch to automatically form a trunk group that is dynamic on both ends of the link, the ports on one end of a set of links must be LACP Active. The ports on the other end can be either LACP Active or LACP Passive. The active command enables the switch to automatically establish a (dynamic) LACP trunk group when the device on the other end of the link is configured for LACP Passive. 11-15