IBM 88410EU User Manual - Page 121
diagnostics
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Note: See "System replaceable units" on page 144 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 1301 (I2C cable to front panel not found) 1. Verify operator information panel cable is connected to J40 on system board. 2. Cable. 3. Front panel 4. Power switch assembly 5. System board 1302 (I2C cable from system board to power on and reset switches not found) 1. Verify power on and reset switch cable is connected to J42 on system board. 2. Cable. 3. Power switch assembly 4. System board 1303 (I2C cable from system board to power backplane not found) 1. Cable 2. Power cage assembly, if installed 3. System board 1304 (I2C cable to diagnostic LED board not found) 1. Verify light path diagnostics panel cable is connected to J36 on system board. 2. Power switch assembly. 3. System board. 1600 v System board (The system management processor is not functioning) Do the following before replacing a FRU: 1. Ensure that BMC reset switch is in the OFF position. 2. Remove the ac power to the server, wait 20 seconds; then, reconnect the ac power. Wait 30 seconds; then, turn on the server. 1601 1. Remote Supervisor Adapter, if installed (The system is able to communicate to the system management processor, but the 2. System board system management processor failed to respond at the start of POST.) Do the following before replacing a FRU: 1. Remove the ac power to the server, wait 20 seconds; then, reconnect the ac power. Wait 30 seconds; then, turn on the server. 2. Flash update the system management processor. 1602 (Optional service processor not properly installed.) Disconnect all server and option power cords from server, wait 30 seconds, reconnect, and retry. Chapter 6. Symptom-to-FRU index 111