IBM 88410EU User Manual - Page 124
Light, diagnostic, errors
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Note: See "System replaceable units" on page 144 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 00181000 (PCI error) v Adapter v System board 01295085 (ECC checking hardware test error) 1. System board 2. Microprocessor 01298001 (System BIOS installed on this server does not support level of processor) 1. Ensure all microprocessors have the same cache size. 2. Microprocessor 1. 01298002 (System BIOS installed on this server does not support level of processor) 1. Ensure all microprocessors have the same cache size. 2. Microprocessor 2. 01298101 (System BIOS installed on this server does not support level of processor) 1. Ensure all microprocessors have the same cache size. 2. Microprocessor 1. 01298102 (System BIOS installed on this server does not support level of processor) 1. Ensure all microprocessors have the same cache size. 2. Microprocessor 2. I9990301 (Hard disk sector error) 1. Hard disk drive 2. SCSI backplane 3. Cable 4. System board I9990305 (Hard disk sector error, no operating system installed) 1. Install operating system to hard disk. I9990650 (AC power has been restored) 1. Check cable. 2. Check for interruption of power. 3. Power cable. Light path diagnostic errors Note: See "System replaceable units" on page 144 to determine which components should be replaced by a field service technician. Diagnostics panel lit LED FRU/action PS 1 (power supply 1 failure or removal) Note: If this LED is blinking it indicates that power supply 1 has been removed in a redundant power supply configuration. 1. Power supply 1 2. System board PS 2 (power supply 2 failure or removal) Note: If this LED is blinking it indicates that power supply 2 has been removed in a redundant power supply configuration. 1. Power supply 2 2. System board CONFIG (invalid configuration exists) Note: Check the panel for other lit LEDs. 1. Run Configuration/Setup Utility program and make sure microprocessors and memory are configured correctly. 2. Follow FRU/action for other lit LEDs or system-log errors. 3. System board. 114 xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide