IBM 88410EU User Manual - Page 128
Microprocessor
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Note: See "System replaceable units" on page 144 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 035-253-s99 (RAID adapter initialization failure) 1. ServeRAID adapter in slot s is not configured properly. Obtain the basic and extended configuration status and see the ServeRAID Hardware Maintenance Manual for more information. 2. Cable. 3. SCSI backplane. 4. Adapter. 035-XXX-099 1. No adapters were found. 2. If adapter is installed re-check connection. 035-XXX-s99 1. RAID adapter (Failed RAID test on PCI slot s. s = number of failing PCI slot. Check System Error Log 2. SCSI backplane before replacing a FRU.) 3. Cable 035-XXX-snn (Check System Error Log before replacing a FRU. s = number of failing PCI slot, nn = SCSI ID of failing fixed disk.) v Hard disk drive with SCSI ID nn on RAID adapter in PCI slot s. 075-XXX-000 (Failed power supply test) v Power supply 089-XXX-001 (Failed microprocessor test) 1. Microprocessor 1 2. System board 089-XXX-002 (Failed optional microprocessor test) 1. Optional microprocessor 2 2. System board 166-051-000 System Management: Failed (Unable to communicate with RSA. It may be busy. Run the test again.) 1. Flash latest levels of firmware (BIOS, service processor, diagnostics) 2. Rerun diagnostic test. 3. Correct other error conditions (including failed system management tests and items logged in Remote Supervisor Adapter II SlimLine system-error log and BMC log) and retry. 4. Disconnect all server and option power cords from server, wait 30 seconds, reconnect, and retry. 5. Remote Supervisor Adapter II SlimLine. 166-060-000 System Management: Failed (Unable to communicate with RSA. It may be busy. Run the test again.) 1. Flash latest levels of firmware (BIOS, service processor, diagnostics) 2. Rerun diagnostic test. 3. Correct other error conditions (including failed system management tests and items logged in Remote Supervisor Adapter II SlimLine system-error log and BMC log) and retry. 4. Disconnect all server and option power cords from server, wait 30 seconds, reconnect, and retry. 5. Remote Supervisor Adapter II SlimLine. 118 xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide