IBM 88410EU User Manual - Page 28
Replacing, front
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Replacing a front fan (1 or 2) Complete the following steps to replace fan 1 or 2: Attention: To ensure proper server operation, if a fan fails, replace it within 48 hours. Fan-assembly latch Hot-swap fan assembly Front fan 1or 2 Complete the following steps to replace hot-swap-fan 1 or 2: 1. Read the safety information beginning on page v and "Installation guidelines" on page 11. 2. Remove the cover. See "Removing the left-side cover" on page 14. The LED on the failing fan assembly will be lit. Attention: To ensure proper system cooling, do not remove the left-side cover for more than 30 minutes during this procedure. 3. Place your fingers into the fan-assembly latch on the top of the failing fan. 4. Squeeze the fan-assembly latch together and lift the fan out of the server. 5. Position the new fan so that the LED on the fan is closest to the front of the server. 6. Push the replacement fan assembly into the server until it clicks into place. 7. Make sure that the FAN LED on the diagnostic LED panel (see "Light path diagnostics panel" on page 84) is not lit. If the FAN LED is lit, reseat the fan. 8. Replace the cover. See "Installing the server bezel and left-side cover" on page 46. 18 xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide