IBM 88410EU User Manual - Page 81
adapter-retention
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Complete the following steps to remove the adapter-support bracket as a single unit: 1. Disconnect any cables that are connected to the full-length adapters. 2. Lift the adapter-retention clip on top of the adapter-support bracket (for the location of this clip, see the illustration at "Installing or replacing a hot-plug adapter (slot 6)" on page 28; then, remove the full-length adapters and plastic dividers. 3. Remove the adapter-support bracket. a. Press the release tab on each end of the adapter-support bracket. There are two latches; one at each end of the adapter-support bracket. b. Slide the adapter-support bracket out of the guides; then, remove it from the server. Note: To reinstall the adapter-support bracket and other components that you removed or disconnected, reverse the preceding steps. Remember to reroute the cables that you disconnected and to reconnect the center-fan cable to the system board (see "System-board internal connectors" on page 78). Chapter 4. Service replaceable units 71