IBM 88410EU User Manual - Page 59
Connecting, cables
View all IBM 88410EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Connecting the cables Notes: 1. Make sure you turn off the server before connecting any cables to or disconnecting any cables from the server or hot-plug adapter. 2. For additional cabling instructions, see the User's Guide on the IBM xSeries Documentation CD and the documentation that comes with the options. It might be easier for you to route any cables before you install certain options. 3. Cable identifiers are printed on the cables that come with the server and options. Use these identifiers to connect the cables to the correct connectors. For example, the hard disk drive cables are labeled "HDD option." Two cable-restraint brackets are on the rear of the server. Route the power cords through the power-cord restraint bracket. After you connect the cables to the selected devices, route the cables (for example, the cables that are connected to the I/O connectors) through the I/O cable-restraint bracket. See the following illustrations for the locations of the input and output connectors on the server. Note: The USB 3 connector is on the front of the server. ASM Ethernet link LED Remote Supervisor Adapter II SlimLine Ethernet Ethernet activity LED Power cord connector AC power LED DC power LED Keyboard connector Mouse connector Parallel connector Serial 1 connector USB 1 connector Ethernet link 2 status LED Ethernet connectors 1 and 2 USB 2 connector Video connector Ethernet link 1 status LED POWER SUPPLY FILLER ATTENTION: REQUIRED FOR SYSTEM COOLING WITH EMPTY SLOT DO NOT THROW AWAY Serial 2 connector Chapter 3. Installing options 49