IBM HS12 Service Guide - Page 147

Diagnostic messages Use this information to review the diagnostic error messages and resolve any errors that might occur in the blade server. If the diagnostic programs generate error codes that are not listed in the table, make sure that the latest level of the BIOS code is installed. To download the latest firmware for the blade server, go to http://www.ibm.com/systems/support/. The following table describes the messages that the diagnostic programs might generate and suggested actions to correct the detected problems. Follow the suggested actions in the order in which they are listed in the action column. In the error codes, x can be any numeral or letter. However, if the three-digit number in the central position of the code is 000, 195, or 197, do not replace a CRU or FRU. These numbers appearing in the central position of the code have the following meanings: 000 The blade server passed the test. Do not replace a CRU or FRU. 195 The Esc key was pressed to end the test. Do not replace a CRU or FRU. 197 This is a warning error, but it does not indicate a hardware failure; do not replace a CRU or FRU. Take the action that is indicated in the Action column, but do not replace a CRU or a FRU. See the description for Warning in the section "Diagnostic text messages" on page 134 for more information. BMC self tests Use this information to resolve BMC self-test errors by referencing the error codes and following the suggested corrective actions. Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. Chapter 6. Diagnostics 135