IBM HS12 Service Guide - Page 57
Attention, Move the retaining clips on the ends of the DIMM connector to the open
![]() |
UPC - 883436037129
View all IBM HS12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
2. The illustrations in this document might differ slightly from your hardware. To remove a DIMM, complete the following steps. DIMM 1 DIMM 2 DIMM 3 DIMM 4 DIMM 5 DIMM 6 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 31. 2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing the blade server from the BladeCenter unit" on page 33). 3. Remove the blade server cover (see "Removing the blade server cover" on page 35). 4. If an optional expansion unit is installed, remove the expansion unit (see "Removing an optional expansion unit" on page 37). DIMM Retaining clip Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently. Move the retaining clips on the ends of the DIMM connector to the open position by pressing the retaining clips away from the center of the DIMM connector. 5. Using your fingers, pull the DIMM out of the connector. 6. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Chapter 5. Removing and replacing blade server components 45
![](/manual_guide/products/ibm-hs12-service-guide-b4c349d/57.png)