IBM HS12 Service Guide - Page 48
Installing the blade server cover
![]() |
UPC - 883436037129
View all IBM HS12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Blade server cover Cover pins Blade server cover release 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 31. 2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing the blade server from the BladeCenter unit" on page 33 for instructions). 3. Carefully lay the blade server down on a flat, static-protective surface, with the cover side up. 4. Press the blade server cover release on each side of the blade server or expansion unit and lift the blade server cover open, as shown in the illustration. 5. Lift the cover from the blade server. 6. If you are instructed to return the cover, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Installing the blade server cover Use this information to install the cover on the blade server. Note: 1. The following illustration shows how to install a blade server cover on a blade server. 2. The illustrations in this document might differ slightly from your hardware. To install the blade server cover, complete the following steps. Statement 21 CAUTION: Hazardous energy is present when the blade server is connected to the power source. Always replace the blade server cover before installing the blade server. 36 BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide
![](/manual_guide/products/ibm-hs12-service-guide-b4c349d/48.png)