IBM HS12 Service Guide - Page 60
Removing a concurrent KVM card, Attention, Important
UPC - 883436037129
View all IBM HS12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
DIMM Retaining clip a. Turn the DIMM so that the DIMM keys align correctly with the connector on the system board. Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently. b. Make sure that the small tabs on the retaining clips are in the notches on the DIMM. If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly installed. Press the DIMM firmly into the connector, and then press the retaining clips toward the DIMM until the tabs are fully seated. When the DIMM is correctly installed, the retaining clips are parallel to the sides of the DIMM. Important: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly installed. In this case, open the retaining clips and remove the DIMM; then, reinsert the DIMM. Removing a concurrent KVM card Use this information to remove a CKVM card from the blade server. Note: 1. The following illustration shows how to remove the concurrent KVM (cKVM) card from the system board. 2. The illustrations in this document might differ slightly from your hardware. To remove a cKVM card, complete the following steps. 48 BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide