Konica Minolta AccurioPress C2060 IC-314 User Guide - Page 239

Finishing tab in the job parameters window 229 Parameter Marks and barcodes Option Corner mark offset Barcode offset End mark Description The corner mark is placed in a range of 0 mm to 25 mm (horizontal and vertical distance). Note: This option is available for the DSF‑2000. Paper feed direction-The whole bar code should be within 3 mm to 20 mm from lead edge Paper width direction: The whole bar code should be within 25 mm to 60 mm from the right edge. The Duplo DSF-2000 includes an end mark detector that can detect collation and paper feed errors, and prevents binding errors. Enables you to add a mark set that was defined in the Resource Center, and define on which sheets the marks appear. Provides the following options: ● All-Prints the marks on each sheet in your job. ● Repetition-Prints the marks according to the frequency that you define-for example, if you set the repetition to 3, the marks will be printed every third sheet. ● Sheet Range-Prints the marks according to the sheet range that you defined. Provides the following options: ○ Type a range of sheets with a hyphen between the starting and ending numbers in the range-for example, 1-5. ○ Type a range of sheets with a hyphen or comma between the starting and ending numbers, and where the last sheet=n. ● 1,n (first and last sheets) ● n-1 (the sheet before last) ● n- (the integer stands for the number of sheets before the last sheet) Note: The sheet range option is applicable to finishing marks, registration marks and bar codes. If Sheet Range is selected and a range is not entered, the job will not be submitted/saved.