Panasonic PT-DZ12000U Operating Instructions - Page 77

Projector setup MENU ENTER DEFAULT This menu can be used to make a variety of picture and projector settings. MENU Press to display the MAIN MENU screen. MAIN MENU PICTURE POSITION ADVANCED MENU DISPLAY LANGUAGE DISPLAY OPTION PROJECTOR SETUP P IN P TEST PATTERN SIGNAL LIST SECURITY NETWORK MENU SELECT ENTER SUB MENU Press to select "PROJECTOR SETUP". Press to display the "PROJECTOR SETUP" menu. Setting a projector ID The projector has an ID number setting function that helps the user to control two or more projectors either simultaneously or separately with a single remote control. The ID number is set to "ALL" by default. Hence the ID number need not be set when only one projector is used. 1. Press ▲▼ to select "PROJECTOR ID". PROJECTOR SETUP PROJECTOR ID INSTALLATION 1/2 ALL FRONT-FLOOR 2. Press ◄► to switch "PROJECTOR ID". • The setting will change as follows each time ◄► is pressed. ALL 1 64 2 3. Press MENU twice. • This concludes the setting procedure and the on-screen indications disappear and the normal screen appears again. Note • The ID number can be set to "ALL", or selected from "1" to "64". • If the projectors are given ID numbers, their remote controls must be assigned the same ID numbers, respectively. • If the ID number of a projector is set to "ALL", it can be controlled by the remote control or the PC with any ID number. If multiple projectors are used and some of them have their IDs set to "ALL", they cannot be controlled separately from the projectors with other ID numbers. For details on remote control ID setting, see page 18. Special Features ENGLISH - 77