Cisco 7912G Administration Guide - Page 154
Tone Parameters
UPC - 746320852409
View all Cisco 7912G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Configuration Parameters Appendix A Additional Configuration Methods, Parameters, and Procedures Table A-1 Network Parameters (continued) Parameter Nprintf Description IP address and port of a server to which Cisco IP Phone troubleshooting messages are sent. TraceFlags Enables specific trace features. 1. CDP = Cisco Discovery Protocol Usage Enter the extended IP address of the server to which troubleshooting messages are sent and collected in a log file. The default value is 0, which specifies that no messages are sent. Note To collect troubleshooting messages, the prserv.exe tool must be running on the server specified with this parameter. For more information about using Nprintf and preserv.exe to collect troubleshooting information, see the "Collecting Information for Troubleshooting" section on page A-30. Bit map Bit 0-31-Reserved for future use. Should be set to zero (0). The default setting is 0x00000000. Tone Parameters Table A-2 describes the tone parameters that you can configure through a phone's profile file or through its Tone Parameters web page. A-16 Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G OL-6313-01