Cisco 7912G Administration Guide - Page 155
Table A-2, Tone Parameters, volume increases or decreases when a user continues
UPC - 746320852409
View all Cisco 7912G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Appendix A Additional Configuration Methods, Parameters, and Procedures Configuration Parameters Table A-2 Tone Parameters Parameter SigTimer RingCadence Description Usage Timeout values for signaling events. Bit map, as follows: Bits 0 - 7-Interval between each call-waiting tone. The range is 0 to 255. The setting 0 specifies the factory default. Any other number specifies the interval in 0.1 second increments. The default setting is 100 (0x64, 10 seconds). Bits 8 - 27-Reserved for future use. Should be set to 0. Bits 28 - 29-First repeat interval for the Volume and Navigation buttons. That is, the button takes effect the first time a user presses and holds down the button for the interval specified. The range is 0 to 3 (0 = one second; 2 = two seconds; 3 = three seconds; 1 disables the Volume and Navigation button repeat interval). The default value is 0. Bits 30 - 31-Subsequent repeat interval for the Volume and Navigation buttons. For example, the volume increases or decreases when a user continues to hold down the Volume button for the interval specified. The range is 0 to 1 (0=0.25 seconds; 1 = 0.50 seconds; 2=0.75 seconds; 3 = one second). The default value is 0. Ringer cadence pattern. Three comma-separated integers, a,b,c, where: • a-Number of seconds to wait before turning the ring on. • b-Number of seconds to wait before turning the ring off. • c-Ring frequency. The default value is 2,4,25. Note The ring frequency portion of this parameter is currently not enabled and must be set to 25. Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G OL-6313-01 A-17