Dell C1765NFW Dell Users Guide - Page 119

Fax Settings Purpose: To configure the basic fax settings. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Values: Receive Mode Auto Receive Fax Auto Receive Tel/Fax Auto Receive Answer/Fax Line Monitor Ring Tone Volume Line Type Tone/Pulse Resend Delay Redial Attempts Redial Delay Junk Fax Setup Remote Receive Remote Receive Tone Fax Header Fax Header Name Telephone Automatic fax reception is turned off. You can receive a fax by picking up the handset of the external telephone, and then pressing the remote receive code. Fax* Automatically receives faxes. Telephone/Fax When the printer receives an incoming fax, the external telephone rings for the time specified in Auto Receive Fax/Tel, and then the printer automatically receives a fax. If an incoming call is not a fax, the printer beeps from the internal speaker indicating that the call is a telephone call. Answer Machine/ Fax The printer can share a telephone line with an answering machine. In this mode, the printer will monitor the fax signal and pick up the line if there are fax tones. If the phone communication is using serial transmission in your country (such as Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), this mode is not supported. DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be installed on your telephone line by the telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern, configure the fax setup to monitor for that specific ring pattern. Sets the interval at which the printer goes into the fax receive mode after receiving an incoming call. Sets the interval at which the printer goes into the fax receive mode after the external telephone receives an incoming call. Sets the interval at which the printer goes into the fax receive mode after the external answering machine receives an incoming call. Sets the volume of the line monitor, which audibly monitors a transmission through the internal speaker until a connection is made. Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through the internal speaker when Receive Mode is set to Telephone/Fax. Sets the line type. Sets the dialing type. Specifies the interval between transmission attempts. Specifies the number of redial attempts to make when the destination fax number is busy. If you enter 0, the printer will not redial. Specifies the interval between redial attempts. Sets whether to reject faxes sent from unwanted numbers by accepting faxes only from the fax numbers registered in the Phone Book. Sets whether to receive a fax by pressing a remote receive code on the external telephone. Specifies the remote receive code in two digits to start Remote Receive. Sets whether to print the information of sender on the header of faxes. Sets the name of sender to be printed on the header of faxes. Up to 30 alphanumeric characters can be entered. Dell™ Printer Configuration Web Tool 117