Epson 6200L Reference Guide - Page 102

If you select TBCP (Tagged Binary Communications Protocol), all 3 data except for special control characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial communications ports and are faster then sending data in the ASCII format. 3 Note: The Tagged binary communications protocol cannot be used with AppleTalk. 3 Send CTRL-D Before Each Job Specify whether a CTRL+D character should be sent at the 3 beginning of every PostScript document. CTRL+D at the 3 beginning-of-file (BOF) will reset your printer to its default settings to ensure that prior print jobs will not affect the current print job. However, activating this setting may cause the print job 3 to fail if it is connected through a network instead of the parallel or serial interface. Send CTRL-D After Each Job 3 Specify whether a CTRL+D character should be sent at the end of every PostScript document. CTRL+D at the end-of-file (EOF) will 3 reset your printer to its default settings to ensure that the current print job will not affect future print jobs. However, activating this setting may cause the print job to fail if it is connected through a network instead of the parallel or serial interface. 3 Job Timeout 3 Specify the maximum number of seconds that can elapse for a print job to get from the computer to the printer before the printer stops trying to print the document. If you enter "0" (zero), the printer will continue trying to print indefinitely. 3 3 Using the Printer Driver For Windows 102