Epson 6200L Reference Guide - Page 273

Toner Out Allows you to set whether the printer should continue or stop 7 printing when the printer encounters a Toner Out error. If set to Continue (default), the printer continues printing regardless of the error. This setting is recommended if you are physically 7 distant from the printer. If set to Stop, the printer stops printing when it encounters the Toner Out error. 7 Image Optimum (LaserJet4 only) 7 Allows you to print complex graphics even when print data reaches the memory limit. When set to On, the amount of graphics data is automatically reduced, allowing complex documents to be printed. However, the quality of the graphics is reduced. 7 Tray Assign Changes the assignment for the paper source select command. 7 When 4 is selected the commands are set as compatible with the HP LaserJet4. When 4K is selected the commands are set as 7 compatible with the HP LaserJet 4000, 5000, and 8000. When 5S is selected the commands are set as compatible with the HP LaserJet 5S. 7 MP Tray Size 7 Allows you to set the paper size for the MP tray. The options are the same as those under Page Size. This setting affects the setting under other emulation modes as well. Paper Type 7 Allows you to specify the type of paper to improve print quality. 7 Thick W (188 mm wide or wider) is for paper with a width of more than 188 mm. Thick N (160 to 188 mm wide) is for thick and narrow paper like envelopes. Transparency is for transparencies. 7 Always use Normal (default) unless print quality problems occur. Using the Remote Control Panel Utility (EPL-6200 only) 273