Epson 6200L Reference Guide - Page 92

PostScript language level 3 Specify the PostScript language level to use. Select the highest PostScript language level that your printer supports to optimize its features. Use a lower PostScript language level only if you are 3 experiencing printing problems or if you intend to print the file using another printer. 3 Data format Select the data format to use. The options are ASCII data, Binary communications protocol, Tagged binary communications 3 protocol, and Pure binary data. However, only ASCII data and Tagged binary communications protocol can be selected when running under Windows Me/98/95. If you select ASCII data, print data is sent in the ASCII (7-bit) 3 format, which may take longer to print, but which can be sent through any I/O channel, including serial, parallel, and Ethernet. 3 If you select Tagged binary communications protocol, all data except for special control characters is sent in binary (8-bit) format. The binary format can be sent over parallel or serial communications ports and are faster then sending data in the 3 ASCII format. Note: 3 The Tagged binary communications protocol cannot be used with AppleTalk. 3 Send CTRL+D before job 3 Select this check box to specify for the CTRL+D character to be sent at the beginning of every PostScript document. CTRL+D at the beginning-of-file (BOF) will reset your printer to its default settings to ensure that prior print jobs will not affect the current 3 print job. However, activating this setting may cause the print job to fail if it is connected through a network instead of the parallel or serial interface. 3 Using the Printer Driver For Windows 92