Epson LQ 1050 Technical Manual - Page 152
Step 15: Remove
View all Epson LQ 1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
REV.-A Step 12: Hold carriage guide shaft B in place and tighten the HNO (4) nut. Step 13: Move the carriage to the left end, and measure the gap value again to confirm that it is correct. Step 14: Move the carriage to the right end, and measure the gap value again to confirm that it is correct. Step 15: Remove the printhead. Step 16: Reinsert the ribbon mask into the ribbon mask holder. Step 17: Connect the FPC to the printhead, and reinstall the printhead onto the carriage. 4-39
REV.-A
Step 12: Hold carriage guide shaft B in place and tighten the HNO (4) nut.
Step 13: Move the carriage to the left end, and measure the gap value again to confirm that it is correct.
Step 14: Move the carriage to the right end, and measure the gap value again to confirm that it is correct.
Step 15: Remove the
printhead.
Step 16: Reinsert the ribbon mask into the ribbon mask holder.
Step 17: Connect the FPC to the
printhead,
and reinstall the
printhead
onto the carriage.
4-39