HP 4200n HP Jetdirect Print Servers - Administrator Guide - Page 288

Table C.2 HP Jetdirect Graphical Control Panel Menu (6 of 7) Menu Item IPX/SPX Options Description of settings MANUAL SETTINGS (Available only if CONFIG METHOD is set to MANUAL) Configure parameters directly from the printer control panel: G IP ADDRESS n.n.n.n: The unique IP address of the printer, where n is a value from 0 to 255. G SUBNET MASK m.m.m.m: The subnet mask for the printer, where m is a value from 0 to 255. G SYSLOG SERVER n.n.n.n: The IP address of the syslog server used to receive and log syslog messages. G DEFAULT GATEWAY n.n.n.n: The IP address of the gateway or router used for communications with other networks. G IDLE TIMEOUT: The time period, in seconds, after which an idle TCP print data connection is closed (default is 270 seconds, 0 disables the timeout). DNS SERVER (620n Only) Specify the IP address (n.n.n.n) of the DNS Server. ENABLE ON: Enable the IPX/SPX protocol OFF: Disable the IPX/SPX protocol FRAME TYPE Selects the frame type setting for your network. AUTO (default): Automatically sets and limits the frame type to the first one detected. EN_8023, EN_II, EN_8022, EN_SNAP: Frame type selections for Ethernet networks. TR_8022, TR_SNAP: Frame type selections for Token Ring networks. SOURCE ROUTING (Token Ring only) Specify the NetWare Source Routing parameter AUTO (default): The type of source routing required on the network is automatically sensed OFF: All packets are sent without source routing, and only packets from the same ring are received. ALL ROUTES and SINGLE ROUTES: All packets are sent with source routing (broadcasts, and when the route is unknown) ENWW The HP Jetdirect Control Panel Menu 288