HP 4200n HP Jetdirect Print Servers - Administrator Guide - Page 80

Command Line Interface (Default) Using the Telnet command line interface, you can set configuration parameters using the following procedures: Note During a Telnet session, enter ? to view available configuration parameters, the correct command format, and a list of commands. To list additional (or advanced) commands, enter the command advanced befored entering ?.. To display current configuration information, enter /. 1. At the Telnet prompt ">" type: : then press Enter, where refers to the configuration parameter you are defining, and refers to the definitions you are assigning to that parameter. Each parameter entry is followed by a carriage return. See Table 3.4 for configuration parameters (firmware version x.25.00 or later). 2. Repeat the previous step to set any additional configuration parameters. 3. When you have finished typing the configuration parameters, type exit or quit (depending on your system). When prompted whether to save settings that you have changed, enter Y (default) for Yes, or N for No. If you enter save instead of exit or quit, you will not be prompted to save settings. ENWW TCP/IP Configuration 80