HP BL260c HP BladeSystem c-Class Enclosure Troubleshooting Guide - Page 34

Step Step 8 Step 9 Step 10 Power supply failure action and verification Verification If all power supply power LEDs remain on and all fault LEDs remain off, then continue as indicated: • When troubleshooting an HP BladeSystem c7000 Enclosure, continue to the next step. • When troubleshooting an HP BladeSystem c3000 Enclosure, continue with step 5. If the power LEDs and the fault LEDs indicate a fault, then the test the OA tray: 1 Remove the OA tray. 2 Install a known-working OA tray. 3 Check the status of the power supply LEDs. If the power supply LEDs indicate a fault, then the OA tray is not causing the error. Continue to step 14. Action Install the original Onboard Administrator in OA bay 1. Verification If the Onboard Administrator health LED is green and a second Onboard Administrator was originally installed, then continue to step 10. If the power supply fault LEDs are on, then continue to the next step. For all other LED indications, continue to step 13. Action Remove the suspect Onboard Administrator from OA bay 1. Install a known-working Onboard Administrator in OA bay 1. Verification If the Onboard Administrator health LED is green and a second Onboard Administrator was originally installed, then continue with step 10. If the Onboard Administrator is off and there was no Onboard Administrator originally installed in OA bay 2, then continue to step 13. If the power supply fault LEDs are on, then the original Onboard Administrator is not causing the issue. Perform the following substeps: 1 Remove the current Onboard Administrator. 2 Install the original Onboard Administrator in OA bay 1. 3 Continue to the next step. Action If troubleshooting an HP BladeSystem c7000 Enclosure: 1 Remove the Onboard Administrator. 2 Remove the OA tray. 3 Install a known-working OA tray. 4 Install the Onboard Administrator in OA bay 1. Enclosure troubleshooting 34