Panasonic WJHD500A WJHD500A User Guide - Page 10

s WV-CU50 Remote Controller *1 *2 *3 Remote Controller WV-CU50 &1 LOCK SET LINK 1 2 3 4 *4 SPOT &2 MULTISCREEN COPY 5678 *5 MULTISCREEN REC &3 SELECT PREVIEW 9 10 11 12 &4 *6 SEQUENCE EL-ZOOM &5 13 14 15 16 &6 GROUP *7 &7 SELECT STOP PLAY/ PAUSE REC *8 INDEX &8 *9 REV FWD ALARM ALARM &9 SEARCH RESET (0 DISPLAY REC STOP (1 *0 (2 REMOTE (3 &1 Lock Button (LOCK) Toggles to enable or disable the button lock function on both front panels of the Disk Recorder and Remote Controller. The LED indicates the status as shown below. On: The button lock is enabled. Off: The button lock is disabled. While On, the button lock will be released only if the preset password is entered in the password inquiry window. &2 Monitor Selection Button (SPOT/MULTISCREEN) Selects either the Spot or Multiscreen Monitor for which you wish to control the display on the screen. The LED indicates the status as shown below. On: The Spot Monitor is selected. Off: The Multiscreen Monitor is selected. 10 &3 Multiscreen Selection Button (MULTISCREEN SELECT) Selects the multiscreen pattern to be displayed on the Multiscreen Monitor. Pressing this button will change the screen pattern as follows. 4 → 7 → 9 → 10 → 13 → 16 → 4 screen segments &4 Recording Preview Button (REC PREVIEW) Use this button to display the playback image with the live images on the Multiscreen Monitor. The LED indicates the status as shown below. On: The selected playback image is displayed Blinking: Prompts you to select the numeric button for displaying the playback image. &5 Sequence Button (SEQUENCE) Runs the assigned sequence on the selected monitor screen for the specified duration. During the sequence, pressing this button will pause the sequence that is being run on the monitor screen. The LED indicates the status as shown below. On: Sequence is being run. Blinking: Sequence is in pause mode.