Pioneer AVIC-9DVD Owner's Manual - Page 145

Appendix Route Setting Information sRoute search specifications Your Navigation System sets a route to your destination by applying certain built-in rules to the map data. This section provides some useful information about how a route is set. Caution When a route is calculated, the route and voice guidance for the route is automatically set. Also, for day or time traffic regulations, only information about traffic regulations at the time when the route was calculated is shown. For example, if a street is open during the morning only, but you arrive later, it would be against the traffic regulations so you cannot drive along the set route. When driving, please follow the actual traffic signs. Also, the system may not know some traffic regulations. • The calculated route is one example of the route to your destination decided by the Navigation System whilst taking the type of streets or traffic regulations into account. It is not necessarily an optimum route. (In some cases, you may not be able to set the streets you want to pass. If you want to pass a certain street, set the way point on that street.) • The route set by your Navigation System is based on the assumption that the driver does not know the area. Thus, the streets known to local drivers, such as small streets or special roads, may not be used for the set route. • If there are fewer than six recommended routes, some route options may become the same route. If visiting points are set, only one route is calculated. • Route setting is limited to the range of the disc in use. Additionally, if the destination is too far, there may be instances where the route cannot be set. (If you want to set a long-distance route going across several areas, set way points along the way.) • If you try to select a point on a freeway as a destination, a location on a nearby road (such as below the freeway) may be chosen instead. • During voice guidance, turns and junctions from freeway are automatically announced. (However, if you pass junctions, turns, and other guide points in rapid succession, some may not be announced.) • Incorrect guidance may be given at freeway junctions if the exit lane is particularly long. • It is possible that guidance may direct you off a freeway and then back on again. • If a route along a normal freeway passes near a freeway service area, the system may mistake the ser- vice area for a freeway junction. • In some cases, the set route may require you to travel in the opposite direction to your current heading. In such cases, you are instructed to turn around, so please turn around safely by following the actual traffic rules. • In some cases, guidance may direct you past your destination and then indicate a U-turn to get back to it. • In some cases, a route may begin on the opposite side of a railway or river from your actual current location. If this happens, drive towards your destination for a while, and try route calculation again. • In the following cases, the route that passes through an Area to Avoid may be set: - when your car is in the Area to Avoid - when your destination or way points are in the Area to Avoid - when it is not possible to avoid doing so • If a suitable route cannot be set in compliance with the specified "Detour" parameter or your preference to avoid freeways or a ferry route, the setting or parameter may be ignored. • When there is a traffic jam ahead, if driving through the traffic jam is better than taking the detour, a detour route may not be set. • If your destination is a freeway junction, voice guidance may not announce the junction. • There may be instances when the starting point and the destination point are not on the highlighted route. 143