D-Link DGS-1250 User Manual - Page 120

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide The fields that can be configured or displayed for MLD Snooping Groups Table are described below: Parameter VID Group Address FM Exp (sec) Description Click the radio button and enter a VLAN ID of the multicast group. The range is from 1 to 4094. Click the radio button and enter an IPv6 multicast group address. Displays the filter mode. The following can be displayed: • EX (Exclude) - The filter mode is Exclude. • IN (Include) - The filter mode is Include. Displays the time left in seconds before the entry expires. Click the Find button to locate a specific entry based on the information entered. Click the Show All button to view all the entries. MLD Snooping Mrouter Settings This window is used to display and configure the specified interface(s) as the router ports or forbidden to be IPv6 multicast router ports on the VLAN interface on the Switch. To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Mrouter Settings, as shown below: Figure 5-56 MLD Snooping Mrouter Settings Window The fields that can be configured in MLD Snooping Mrouter Settings are described below: Parameter VID Configuration From Port - To Port Description Enter a VLAN ID between 1 and 4094. Select the port configuration. Options to choose from are: • Port - Select to have the configured ports as being connected to multicastenabled routers. • Forbidden Port - Select to have the configured ports as being not connected to multicast-enabled routers. • Learn pimv6 - Select to enable dynamic learning of multicast router port. Select the appropriate port range used for the configuration here. Click the Apply button to accept the changes made. Click the Delete button to remove the specified entry. 111