D-Link DGS-3630 User Manual 1 - Page 264

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter Interface Name IPv6 Address Description Enter the name of the interface that will be used to create the BFD session here. This name can be up to 12 characters long. Enter the IPv6 address of the BFD peer here. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. IPv6 Route Table This window is used to display and configure the IPv6 route table. To view the following window, click L3 Features > IPv6 Route Table, as shown below: Figure 6-28 IPv6 Route Table Window The fields that can be configured are described below: Parameter IPv6 Address IPv6 Address/Prefix Length Interface Name Connected RIPng OSPFv3 ISIS BGP Database Hardware Summary Description Select and enter the IPv6 address to display here. Select and enter the IPv6 address and prefix length to display here. Select the Longer Prefixes option to display IPv6 routes with prefixes greater than and equal to the prefix length. Select and enter the name of the interface to display here. Select this option to display only connected routes. Select this option to display only RIPng routes. Select this option to display only OSPFv3 routes. Select this option to display only ISIS routes. Select this option to display only BGP routes. Select this option to display all the related entries in the routing database instead of just the best route. Select this option to display only hardware routes. Hardware routes are routes that have been written into the hardware chip. Select this option to display a summary and count of the route sources configured on this Switch. Click the Find button to locate a specific entry based on the information entered. 252