D-Link DGS-3630 User Manual 1 - Page 687

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide To view the following window, click Tools > Trace Route, as shown below: Figure 15-39 Trace Route Window The fields that can be configured in IPv4 Trace Route are described below: Parameter VRF Name IPv4 Address Domain Name Initial TTL Max TTL Port Timeout Length ToS Frequency Source IPv4 Address Description Enter the name of the VRF instance here. This name can be up to 12 characters long. Select and enter the IPv4 address of the destination here. Select and enter the domain name of the destination here. Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255. Enter the Time-To-Live (TTL) value of the trace route request here. This is the maximum number of routers that a trace route packet can pass. The trace route option will cross while seeking the network path between two devices. The range for the TTL is 1 to 255 hops. Enter the port number here. The value range is from 1 to 65535. Enter the timeout period while waiting for a response from the remote device here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds. Enter the length value here. This specifies the number of bytes of the outgoing datagram. The range is from 1 to 1420 bytes. Enter the ToS value here. This specifies the ToS to be set in the IP header of the outgoing datagram. The range is from 0 to 255. Enter the frequency time for the trace route here. The range is from 0 to 86400. Enter the source IPv4 address here. The specified IPv4 address must one of the IPv4 addresses configured for the Switch. 675