D-Link DGS-3630 User Manual 1 - Page 323

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Click the Show All button to display all the entries. MLD Proxy MLD Proxy Settings This window is used to display and configure the MLD proxy settings. The MLD proxy only works in a simple tree topology. Make sure there are no other multicast routers except for the proxy devices in the tree topology. When receiving MLD report packet from a downstream interface, MLD proxy will update its membership database which is generated by merging all subscriptions on any downstream interface. If the database changes the proxy device will send unsolicited reports or leaves from the upstream interface. It can also send membership reports from the upstream interface when queried. To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD Proxy > MLD Proxy Settings, as shown below: Figure 6-102 MLD Proxy Settings Window The fields that can be configured in MLD Proxy Global Settings are described below: Parameter Global State Description Select to globally enable or disable the MLD proxy feature here. Click the Apply button to accept the changes made. The fields that can be configured in MLD Proxy Upstream Settings are described below: Parameter Interface VLAN Upstream Description Enter the VLAN interface ID here. The range is from 1 to 4094. Select to enable or disable the interface as the upstream MLD proxy here. This feature only takes effect if the interface has an IPv6 address configured. Only one upstream interface can exist on an MLD proxy device. Click the Apply button to accept the changes made. 311