D-Link DGS-3630 User Manual 1 - Page 626

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide 12. MPLS L2VPN VPWS Settings L2VC Interface Description VPLS Settings VPLS MAC Address Table VPWS Settings This window is used to display and configure the Virtual Private Wire Service (VPWS) settings. To view the following window, click MPLS L2VPN > VPWS Settings, as shown below: Figure 12-1 VPWS Settings Window The fields that can be configured for VPWS Settings are described below: Parameter Unit Port SVID Peer VC ID Type MTU Description Select the Switch unit ID that will be used here. Select the port that will be used here. Select and enter the encapsulated VLAN ID here. The range is from 1 to 4094. Enter the peer LSR ID here that is used to identify the other end Provider Edge (PE). Enter the Pseudo-Wire (PW) service instance ID here. It is used to uniquely identify the VPWS and it must be unique at both PEs. The range is from 1 to 4294967295. Select the type here. Options to choose from are None, Manual, Raw, Tagged, Manual Raw, and Manual Tagged. For the raw mode, S-tags will not be sent over the PW. For the tagged mode, S-tags will be sent over the PW. By default, the PW type is in the Ethernet-tag mode. Enter the local CE-PE link's MTU value here that will be advertised to the remote peer. If the MTU is configured as 0, the LDP will not advertise the local MTU. The MTU must be same at both the local and remote 614