Dell PowerConnect 3348 User's Guide - Page 220
Configuring LAGs with CLI Commands
View all Dell PowerConnect 3348 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
www.dell.com | support.dell.com LAG Configuration Table Configuring LAGs with CLI Commands The following is an example of how to set up LAG with auto-negotiation disabled, 100Full. At the system prompt, enter the following to set up static link aggregation: console> en console# config console(config)# interface port-channel 1 console(config-if)# no neg console(config-if)# speed 100 console(config-if)# exit console(config)# interface range ethernet 1/e23-24 console(config-if)# no mdix console(config-if)# no neg console(config-if)# speed 100 console(config-if)# duplex full console(config-if)# channel-group 1 mode on console(config-if)# end 220 Configuring Switch Infor mation
220
Configuring Switch Information
www.dell.com | support.dell.com
LAG Configuration Table
Configuring LAGs with CLI Commands
The following is an example of how to set up LAG with auto-negotiation disabled, 100Full.
At the system prompt, enter the following to set up static link aggregation:
console> en
console# config
console(config)# interface port-channel 1
console(config-if)# no neg
console(config-if)# speed 100
console(config-if)# exit
console(config)# interface range ethernet 1/e23-24
console(config-if)# no mdix
console(config-if)# no neg
console(config-if)# speed 100
console(config-if)# duplex full
console(config-if)# channel-group 1 mode on
console(config-if)# end