Dell PowerConnect 3348 User's Guide - Page 53

To configure SNMP station IP address and community string(s): 1 At the console prompt, type Enable. The prompt is displayed as #. 2 Type configure and press . 3 In the configuration mode, type the SNMP configuration command with the parameters including community name (private), community access right (read and write) and IP address, as shown in the example below: console> enable config# configure config(config)# snmp-server community private rw 11.1.1.2 config(config)# exit config# show snmp Community-String Community-Access IP address private readWrite 11.1.1.2 Traps are enabled. Authentication-failure trap is enabled. Trap-Rec-Address Trap-Rec-Community Version System Contact: System Location: This completes the initial configuration of the device from a local terminal. The configured parameters enable further device configuration from any remote location. Advanced Configuration This chapter contains information about dynamic allocation of IP addresses and security management based on the AAA (authentication, authorization and accounting) mechanism. The chapter includes the following topics: • Configuring IP Addresses through DHCP. • Configuring IP Addresses through BOOTP. • Security Management and Password Configuration. Configuring the PowerConnect 3324/3348 Switch 53