Dell PowerConnect 3348 User's Guide - Page 82
Downloading the Software Individually Using the CLI, from the Master Unit to Member Units
View all Dell PowerConnect 3348 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
www.dell.com | support.dell.com 5 Enter console# copy tftp://50.1.1.2/332448-10018.dos unit://2/image. The device software is copied to the Stacking member 2. unit: the //2/image indicates the Stacking member Unit ID to which the software is copied. The following is an example of the information that displays Unit 2: Erased image-1 Copy: 2744590 bytes copied in 00:01:41 [hh:mm:ss] console# 01-Jan-2000 01:01:55 %COPY-W-TRAP: The copy operation was completed successfully 6 Repeat step 5 for each Stacking member. Ensure that the software is copied to the correct Stacking member Unit ID. 7 Enter console# boot system image-2 to set the Image file that is used after the device is reset. 8 Enter console# boot system unit 2 image-1. This indicates that the device is booted from Image 1 after the reboot. 9 Enter console# reload. The following message displays: This command will reset the whole system and disconnect your current session. Do you want to continue (y/n) [n]? 10 Enter Y. The device reboots. 11 Repeat steps 2 and 3 to verify which Image files are active. Downloading the Software Individually Using the CLI This section contains instructions for individually downloading device software to each stacking member: • from a TFTP server to a Master Unit • from the Master Unit to Member Units 82 C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h