Dell PowerConnect 3348 User's Guide - Page 264

www.dell.com | support.dell.com Assigning Ports to VLAN Groups Using CLI Commands The following table summarizes the equivalent CLI commands for assigning ports to VLAN groups as displayed in the VLAN Port Settings page. CLI Command interface ethernet interface switchport mode {access | trunk | general} switchport general pvid vlan-id switchport general allowed vlan add vlan-list [tagged | untagged] switchport general allowed vlan remove vlan-list switchport general ingressfiltering disable Description Enters the interface configuration mode to configure an ethernet type interface. Configures a port VLAN membership mode. Configure the Port VLAN ID (PVID) when the interface is in general mode. Adds VLANs to a general port. Removes VLANs from a general port. Disables port ingress filtering. The following is an example of the CLI commands: Console (config)# interface range ethernet 1/e18 - e20 Console (config-if)# switchport mode access Console (config-if)# switchport general pvid 234 Console (config-if)# switchport general allowed vlan add 1,2,5,6 tagged Console (config-if)# switchport general ingress-filtering disable Defining VLAN LAG Settings The VLAN LAG Settings page provides parameters for managing LAGs that are part of a VLAN. VLANs are composed of individual ports or LAGs. Untagged packets entering the switch on a LAG are tagged as specified by the LAG's PVID. To open the VLAN LAG Settings page: • Click Switch > VLAN > LAG Settings in the Tree View. The VLAN LAG Settings page opens. 264 Configuring Switch Infor mation