Dell PowerEdge T410 Hardware Owner's Manual - Page 122
Installing a Redundant Power Supply, supply blank. See Removing a Power Supply Blank
View all Dell PowerEdge T410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Figure 3-16. Removing and Installing a Redundant Power Supply 1 2 3 1 power supply handle 3 release latch 2 velcro strap Installing a Redundant Power Supply 1 Verify that both power supplies are the same type and have the same maximum output power. NOTE: The maximum output power (shown in watts) is listed on the power supply label. 2 If you are installing a power supply into an empty bay, remove the power supply blank. See "Removing a Power Supply Blank" on page 123. If you are installing a power supply into a bay that has a power supply, see "Removing a Redundant Power Supply" on page 121. 122 Installing System Components
122
Installing System Components
Figure 3-16.
Removing and Installing a Redundant Power Supply
Installing a Redundant Power Supply
1
Verify that both power supplies are the same type and have the same
maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the power
supply label.
2
If you are installing a power supply into an empty bay, remove the power
supply blank. See "Removing a Power Supply Blank" on page 123.
If you are installing a power supply into a bay that has a power supply,
see "Removing a Redundant Power Supply" on page 121.
1
power supply handle
2
velcro strap
3
release latch
1
2
3